Silicone Coated Wipers

Dry wiping the wipers for 3-5 minutes at mid-range speed in a waterless state will give a perfect water repellent effect.

Adopting self-developed water-soluble coating factor, when coating, the coating factor fills the gaps on the surface of the glass that cannot be seen by the naked eye, and at the same time, it forms a uniform hydrophobic layer on the glass, which effectively prevents water molecules from penetrating.

Rainwater falling on the glass bounces up into water droplets and then slides down quickly. When driving at high speeds, the water droplets are also quickly blown away by the wind. You don't even need to turn on the windshield wipers when driving in the rain!

Silicone Coated WipersSilicone Coated Wipers

Tutorials

01 Cleaning glass and removing dirt

Clean the glass, rinse off the dust and sand on the glass.

Use the oil film remover to thoroughly clean the oil film stains on the glass (the commonly used volcanic clay and abrasive clay cloth on the market are unable to thoroughly clean the oil film layer)

Rinse the glass. If the localized area is not thoroughly cleaned, it needs to be re-washed. Until the glass drenching water completely covered to the glass surface, indicating that the glass is thoroughly cleaned!

02 Installation of wipers

Confirm the length of the wiper and the snap of the model, and confirm the direction of the snap. When you hear the snap, the wipers are in place.

When replacing the wipers, make sure that the wipers are turned off!

When replacing the wipers, raise the wiper arm to the upright position.

03 Plating

With the glass clean and free of water, turn on the wipers on medium speed and dry scrape for 3-5 minutes to complete the coating.

F&Q